USER BENEFITS:

• PROTECTS AND SEALS
• PENETRATES
• ECONOMICAL
• EASY TO USE

The photo above dramatically illustrates the rejuvenating and sealing qualities of QUICK-DRY ASPHALT PAVING SEAL. A piece of ordinary dried out asphalt paving is coated on one half with QUICK-DRY ASPHALT PAVING SEAL while the other half is left as it was on the parking lot. Water poured on the coated side sits on top unable to penetrate and breakdown the paving underneath, while the water quickly penetrates the uncoated side, simulating the effect rain has on a parking lot.

Black-top surfaces deteriorate from
exposure to air, sun, rain, freezing weather and snow, from the wear of
traffic and from the hardening of the asphalt surface. If this dry, weakened
condition is not corrected, cracks and breaks soon appear. Moisture seeps
in. The base becomes soft. Traffic churns it up. In low temperatures the
moisture freezes and expands, causing unsightly, dangerous holes to develop.
Expensive time-consuming replacement becomes necessary.

Virtually eliminates this costly problem
quickly, easily, inexpensively by sealing the surface with rejuvenating
asphalt. The result is a pliable surface which gives protection and repels
damaging moisture to extend the service life of the asphalt paved area.

Many paving sealers on the market coat
the black-top surface and are quickly worn off by everyday traffic. This
product penetrates deeply into the asphalt surface establishing a tough
bond and adding new asphalt life.

Helps avoid expensive, time consuming
black-top replacement. Preventive maintenance is quicker, easier and more
economical. You save money by applying QUICK-DRY
ASPHALT PAVING SEAL the moment voids, hairline cracks, or other
small breaks in an asphalt surface are detected. Early repairs help prevent
costly repairs from occurring due to neglect. For maximum service from
asphalt paved surfaces, apply it BEFORE cracks actually appear to save
time, money and the black-top surface.

Newly laid asphalt surfaces should cure
at least nine months before applying QUICK-DRY ASPHALT
PAVING SEAL to allow for the proper setting up time.

 

Comes ready to use. No heating. No thinning.

STEP 1 – Clean
surface to be coated with a stiff brush or broom, or pressure air, removing
all sand, gravel and dirt. Grease and oil residue should be removed. If
possible, wash and allow surface to dry.

STEP 2 - Agitate
by rolling the container on its side a few times.

STEP 3 - Apply
as it comes from the container, using brush, squeegee or spray. Application
rates should not normally exceed 1½ – 2 gallons per 100 sq. ft.

STEP 4 - Force
itinto cracks and voids during application. Do not allow puddles to remain.
Remove by brushing material from low areas.

Under normal conditions, the area sealed
with QUICK-DRY ASPHALT PAVING SEAL is ready
to use in eight hours drying time. A “trial run” may be made after several
hours to determine the seal’s tackiness and whether the area is ready for
normal traffic. Allow extra curing time whenever possible.

Should not be applied to new asphalt
pavements (less than nine months) in that softening may occur. Some asphalt
pavements are highly absorbent. Test a small area to ensure proper results.

GATOR SEAL – a thicker asphalt emulsion
designed to fill in and seal aging alligatored areas on black-top surfaces.

CHUCK-HOLE PATCHING MATERIAL – Ideal
for repairing small holes and broken areas in black-top or asphalt paved
areas. Comes ready to use.